Personal Site

My photo

Application Instructions for using DTG Pretreat Fluid

DTG Pretreat is designed to be applied using a hand-held spray bottle that will mist the fluid as it is being applied to the garment. This means that the user can apply the fluid using an inexpensive spray bottle, but will want one that does not apply large drops of fluid on the garment. A high volume, low pressure (HVLP) sprayer or an automatic pretreatment machine can be used to apply the fluid to the garment.

Click here to download a printable version of these instructions.

Step-by-Step Instructions:
Step #1: Using a hand-held spray bottle, apply the appropriate amount of pretreatment fluid depending on the fabric content for a full 14” x 16” print. For smaller areas, apply a proportional amount of pretreat fluid based on the size of the printable area. You will want to overspray the area a little bit to make sure the pretreatment covers the printable area when loaded on the dtg printer.

* 100% Cotton – 13 to 15 grams

* 50/50 Blends – 16 to 18 grams

* 100% Polyester – 18 to 20 grams
DTG Pretreat CMYK dtg pretreat fluid

Step #2: Heat press the garment to 20-30 seconds at 356 degrees F (or approximately 25-35 seconds for 330 degrees F). Changes in the time and temperature may be used depending on the results of the wash test.

DTG Pretreat CMYK dtg pretreat fluid

Step #3: Print and Cure the garment using the recommended settings for your dtg printer.

DTG Pretreat CMYK dtg pretreat fluid DTG Pretreat CMYK dtg pretreat fluid

NOTE: We recommend that a Print & Wash test be performed before going into production. Download a Print & Wash log by clicking here.

Click on the video below to see the application process and the wash test results.


BECOME A DISTRIBUTOR

If your company is interested in becoming a distributor of DTG Pretreat, click here and complete the form. A representative will contact you back shortly with additional information